Step of work...
- place the thin knot on the piston for bumping test
- put cylinder head
- put air manifold
- tighten the cylinder head
- turn the flywheel two times
- open air manifold
- open cylinder head
Wednesday, June 2, 2010
>WEEK 6< DAY 29 - 13 May 2010 (Thursday)
Continue installation after know a little bit about the gap...The purpose to know the gap is to facilitate the installation in correct way..
Step of work...
- place the thin knot on the piston for bumping test
- put cylinder head
- put air manifold
- tighten the cylinder head
- turn the flywheel two times
- open air manifold
- open cylinder head
Step of work...
- place the thin knot on the piston for bumping test
- put cylinder head
- put air manifold
- tighten the cylinder head
- turn the flywheel two times
- open air manifold
- open cylinder head
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment